Fit check
Sim rig fit check by floor space and storage space
The fit check compares a floor space or a storage space with the listed dimensions of 12 compact wheel stands and cockpits. Floor mode uses the open floor where the rig sits in use. Storage mode uses the closet or corner where a folded rig is kept.
How the fit check works
- A rig fits the floor when its length and width, plus any clearance entered, sit inside the floor space in either direction. A rig turned 90 degrees counts as a fit.
- For a wheel stand, the chair depth is added to the stand length. The driver sits behind the stand on a separate chair.
- Driver height is compared with the manufacturer's driver height range. A rig outside that range is marked in orange and stays in the results.
- Storage mode compares the folded size in any orientation. A rig that has to be stored upright can need more room than the result shows.
- Dimensions marked Not confirmed or Not listed are not used. Those rigs show as Cannot check, with the reason.
The entries are saved in the page link after the # mark. A copied link opens the same measurements again. The calculation runs in the browser.